Connect Systems CS800 remote mount kit


All you need is a cat 5 cable or the 20.00 flat cable remote mount is on radio just pull 4 screws behind head


Unfortunately, Cat5 cable isn't well enough shielded and it introduces "motorboating"




9 comments:

  1. Anonymous6/14/2015

    it look great, I can not wait to get my unit

    ReplyDelete
  2. Unfortunately, Cat5 cable isn't well enough shielded and it introduces "motorboating" just like a cheap mic and an MD-380... :(

    ReplyDelete
  3. I have the remote mount kit with my radio. It doesn't have the pieces shown in the photo. Where can I buy the part that attaches to the backing plate?

    ReplyDelete
  4. Does anyone know where I can buy the mount for the backing plate? That part in not included in my remote mount kit.

    ReplyDelete
  5. Just remove the bezel receiver from the radio itself. The service manual shows 4-scres to remove this. Then the bezel receiver is just reused as the back for the separated head.

    ReplyDelete
  6. Hi guys, where can I purchase this kit? Want to install it in my car.
    73
    Izzy
    4X1UF

    ReplyDelete
    Replies
    1. Anonymous3/20/2017

      where can I purchase this kit?
      Have you contacted:Connect Systems

      Delete
  7. Can you show any pics of how you mounted the CS800 plastic housing to the mounting bracket.

    ReplyDelete
  8. Look on my page at qrz.com
    You'll see the pictures of my mobile installation.
    73
    4X1UF

    ReplyDelete

Thanks for your comments, Comments may take a day to show up

A discussion group about this subject.

Digital Ham Radio / Amateur Radio
DigitalHamRADIO@groups.io
https://groups.io/g/DigitalHamRADIO

Amateur Radio Users Support Group
AmateurRadio@groups.io
https://groups.io/g/AmateurRadio

Note: only a member of this blog may post a comment.